INRUSH LIMITER 1.0 OHMS 36 AMP 32MM FOR DYNACO HAFLER OTHERS AS REQUESTED !

Description

32MM
1 OHM 36AMP INRUSH LIMITER FOR
DYNACO HAFLER AND MANY
OTHERS
. THE TREND FOR INCREASED POWER SUPPLY CAPACITANCE CAUSES GREAT STRAIN ON THE POWER SWITCH AND DIODE BLOCK. THESE LIMITERS HELP TO GREATLY REDUCE THE INITIAL TURN-ON SURGE, PROTECTING YOUR UNIT FROM PREMATURE FAILURE. I STOCK .5 OHMS, 1.0 OHMS AND 2.0 OHMS. THIS LISTING IS FOR 1.0
OHM
36 AMP  HIGH CURRENT LIMITER. IF YOU NEED .5 OHM OR 2.0 OHM, VISIT MY EBAY STORE UNDER ACCESSORIES TO SEE LISTINGS. INRUSH LIMITERS ARE NORMALLY INSTALLED IN SERIES WITH THE POWER SWITCH OR PRIMARY SIDE OF THE POWER TRANSFORMER FOR AUDIO USE. RULE OF THUMB IS IF YOU DOUBLE THE POWER SUPPLY CAPACITANCE USE .5 OHMS, TRIPLE USE THE 1.0 OHM, ETC OR CALCULATE USING OHMS LAW. AS ALWAYS THANKS FOR LOOKING
.
Inrush Current Limiter absorbs high amounts of inrush current when electrical equipment is turned on by
offering a high resistance to current and quickly decreasing in resistance once steady state current begins to
flow through the thermistor.
In a switching power supply, the instantaneous surge energy is caused by the large input filter capacitors and AC
input voltage.
During the absorption of energy, the initial high resistance of the thermistor drops within milliseconds to a
negligible resistance in preparation of allowing high levels steady state current to flow with a minimal loss of
power through the circuit.
The  Inrush Current Limiter will absorb up to 260 joules of input energy and carry 36 amperes of steady
state current.